Journal cover Journal topic
Atmospheric Measurement Techniques An interactive open-access journal of the European Geosciences Union

Journal metrics

  • IF value: 2.989 IF 2.989
  • IF 5-year<br/> value: 3.489 IF 5-year
    3.489
  • CiteScore<br/> value: 3.37 CiteScore
    3.37
  • SNIP value: 1.273 SNIP 1.273
  • SJR value: 2.026 SJR 2.026
  • IPP value: 3.082 IPP 3.082
  • h5-index value: 45 h5-index 45
doi:10.5194/amt-2017-3
© Author(s) 2017. This work is distributed
under the Creative Commons Attribution 3.0 License.
Research article
17 Jan 2017
Review status
A revision of this discussion paper was accepted for the journal Atmospheric Measurement Techniques (AMT) and is expected to appear here in due course.
Use of a Heated Graphite Scrubber as a Means of Reducing Interferences in UV-Absorbance Measurements of Atmospheric Ozone
Andrew A. Turnipseed, Peter C. Andersen, Craig J. Williford, Christine A. Ennis, and John W. Birks 2B Technologies, Inc., 2100 Central Ave., Boulder, CO 80301
Abstract. A new solid-phase scrubber for use in conventional ozone photometers was investigated as a means of reducing interferences from other UV-absorbing species and water vapor. It was found that when heated to 100–130 °C, a tubular graphite scrubber efficiently removed up to 500 ppb ozone and ozone monitors using the heated graphite scrubber were found to be less susceptible to interferences from water vapor, mercury vapor, and aromatic volatile organic hydrocarbons (VOCs) compared to conventional metal oxide scrubbers. Ambient measurements from a graphite scrubber-equipped photometer and a co-located Federal Equivalent Method (FEM) ozone analyzer showed excellent agreement over 38 days of measurements and indicated no loss in the scrubber’s ability to remove ozone when operated at 130 °C. The use of a heated graphite scrubber was found to reduce the interference from mercury vapor to ≤ 3 % of that obtained using a packed-bed Hopcalite scrubber. For a series of substituted aromatic compounds (ranging in volatility and absorption cross section at 253.7 nm), the graphite scrubber was observed to consistently exhibit reduced levels of interference, typically by factors of 2.5 to 20 less than with Hopcalite. Conventional solid-phase scrubbers also exhibited complex VOC adsorption and desorption characteristics that were dependent upon the relative humidity (RH), volatility of the VOC, and the available surface area of the scrubber. This complex behavior involving humidity is avoided by use of a heated graphite scrubber. These results suggest that heated graphite scrubbers could be substituted in most ozone photometers as a means of reducing interferences from other UV-absorbing species found in the atmosphere. This could be particularly important in ozone monitoring for compliance with the U.S. Clean Air Act or for use in monitoring indoor air quality.

Citation: Turnipseed, A. A., Andersen, P. C., Williford, C. J., Ennis, C. A., and Birks, J. W.: Use of a Heated Graphite Scrubber as a Means of Reducing Interferences in UV-Absorbance Measurements of Atmospheric Ozone, Atmos. Meas. Tech. Discuss., doi:10.5194/amt-2017-3, in review, 2017.
Andrew A. Turnipseed et al.
Andrew A. Turnipseed et al.

Viewed

Total article views: 292 (including HTML, PDF, and XML)

HTML PDF XML Total BibTeX EndNote
204 64 24 292 12 22

Views and downloads (calculated since 17 Jan 2017)

Cumulative views and downloads (calculated since 17 Jan 2017)

Viewed (geographical distribution)

Total article views: 292 (including HTML, PDF, and XML)

Thereof 292 with geography defined and 0 with unknown origin.

Country # Views %
  • 1

Saved

Discussed

Latest update: 29 May 2017
Publications Copernicus
Download
Short summary
We investigated a new solid-phase scrubber for use in conventional ozone UV-absorption photometers. A heated graphite scrubber efficiently removed ozone and was less susceptible to interference from water vapor, mercury vapor, and aromatic hydrocarbons compared to conventional metal oxide scrubbers. Reducing interferences from these atmospheric species in conventional ozone photometers could lead to more accurate ozone measurements in compliance monitoring or for indoor air quality.
We investigated a new solid-phase scrubber for use in conventional ozone UV-absorption...
Share